WPI PZMIV Manuel d'utilisateur télécharger pdf (Page 14)

10 World Precision Instruments

APPENDIX: BOOM STAND ASSEMBLY

1. Remove all the parts from the box.

2. Unscrew the hex screw from

Vertical Post. The Vertical Post

should have a cross block

attached to it.

3. Screw Vertical Post and Base

together using the hex screw.

(Insert the screw from bottom of

the base into the threaded section

of Vertical Post.)

4. Insert the Horizontal Bar into the

opening in the cross block with the

slot side facing up.

Two different types of focusing assemblies are available:

Focus Mount

1. Remove the focus mount from the protective packaging

2. Insert the focus mount into the end

of the Horizontal Bar and secure it by

tightening set screw.

3. Tighten one or both hex screws (2.5

mm and 4 mm) so the microscope

head is tiltable but not free to swing.

TIP: The focus mount can be inserted

from the TOP, BOTTOM or END of the

Horizontal Bar. For oblique viewing, set

the focus mount up at various angles and then tighten the handle.

1 2 ... 9 10 11 12 13 14 15 16

Pas de commentaire

WPI PZMIV Manuel d'utilisateur Page 14